FUTABA 12K Instruction Manual page 145

AIL to RUD
Use this mix when you want to mix the rudders
with aileron operation. This allows the aircraft to
bank at a steep angle.
menu and access the setup
screen shown below by pushing
the RTN button.
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
RETURN
Setting method
the RTN button to switch to the data input
*The display blinks.
When selecting a switch, move the cursor to
*For a description of the switch selection method, see the
description at the back of this manual.
Move the cursor to the left or right item
and push the RTN button to switch to the
*When the RTN button is pushed for one second, the rate is
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 1
Winglet
( )
at Flying wing
V-TAIL
RUDDER 2
(Glider: Currently selected condition name)
reset to the initial value.)
and return to the cursor mode.
It can be set by each conditions.
Operation Mode
displayed.
Mode : LIN. / ATL+ / ATL- / SYM.
hardware
<Model Menu (Airplane/Glider Functions)>
AIL 2
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 2
Winglet
(
at Flying wing
RUDDER
RUDDER
<Push Dial>
*The display screen is an example.
The actual screen depends on the
model type.
Actual rate
Range ： -100 ∼ +100%
145
)