FUTABA 12K Instruction Manual page 136

AIL to RUD
This mix is used when you want to coordinate
the rudder with aileron operation for banking at
shallow angles. [Airplane/glider, general]
RUD to AIL
This function is used when you want to mix
the ailerons with rudder input. Rudder is applied
during rolling maneuvers such as knife edge
CAMBER MIX
This mix adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
ELE to CAMBER
This mix is used when you want to the mix
the model. [Airplane/glider, 2 ailerons or more]
CAMB.FLP to ELE
This mix is used to correct for changes in
attitude when the camber flaps are utilized.
BUTTERFLY (Crow)
This function is used to quickly slow the
aircraft and/or reduce the altitude. [Glider, 2
ailerons or more (Flying: 2 ailerons + 1 flap or
more)]
TRIM MIX
The ailerons, elevators, and flaps trim offset
rate can be accessed by selecting a switch or
condition selection as desired. [Glider, 2 ailerons
or more]
AIRBRAKE
This function is used when airbrakes are
RUDDER 1
Winglet
(
at Flying wing
<Model Menu (Airplane/Glider Functions)>
136
AIL1 FLP 3
(Main Aileron) (Brake Flap)
)
AIL 3
FLP 1
(Chip Aileron) (Camber Flap)
V-TAIL
ELEVATOR
RUDDER
(RUDDER 2)
(ELEVATOR 2)
necessary when landing or when diving, etc.
GYRO
This is a dedicated mix when a GYA Series
gyro is used. [Airplane/glider, general]
V-TAIL
This function incorporates the elevators and
rudder input for use with V-tail models. [Airplane/
AILEVATOR (DUAL ELEVATOR)
This function adjusts the elevators and ailerons
WINGLET
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
MOTOR
This function adjusts the operation speed when
the motor of an F5B or other such EP glider is
started by a switch. [Airplane/glider, general]
RUD to ELE
This function is used to correct rolling
general]
SNAP ROLL
This function selects the snap roll switch and
adjusts the amount of servo input. Servo speed
can also be adjusted. [Airplane general]
FLIGHT MODE
T h i s f u n c t i o n s e l e c t s 5 f l i g h t m o d e s .
[Multirotor]
FLP 4
AIL 2 RUDDER 2
(Brake Flap)
(Main Aileron)
(
at Flying wing
FLP 2 AIL 4
(Chip Aileron)
(Camber Flap)
AILVATOR
ELEVATOR
ELEVATOR 2
(AILERON 5)
(AILERON 6)
Winglet
)