Fixed Speed As Setpoint Source - Siemens SINAMICS G120D Original Instructions Manual

8.3.4

Fixed speed as setpoint source

In many applications after switching on the motor, all that is needed is to run the motor at a
constant speed or to switch between different speeds.
Example: After it has been switched on, a conveyor belt only runs with two different
velocities.
Interconnecting the fixed speeds with a main setpoint
Figure 8-10
Table 8- 5
Parameter
p1070 = 1024
p1075 = 1024
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
Fixed speeds as setpoint source
Setting the fixed speed as a setpoint source
Remark
Main setpoint
Interconnecting the main setpoint with fixed speeds.
Additional setpoint
Interconnecting the additional setpoint with fixed speeds
Setting functions
8.3 Setpoints
123