Select Telegram - Siemens SINAMICS G120D Original Instructions Manual

7.3.5

Select telegram

PROFIdrive telegrams
If you have not activated the function "Basic positioner" in the inverter, the following
telegrams will be available:
p0922 =
The following values apply if you have enabled the "Basic positioner" function in the inverter:
A more detailed depiction of the individual telegrams can be found in Section Cyclic
communication (Page 94).
Selecting a telegram
Procedure
Proceed as follows to set a specific telegram in the inverter:
Using STARTER or an operator panel, set parameter p0922 to the appropriate value.
You have set a specific telegram in the inverter.
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
1: Standard telegram 1, PZD-2/2 (factory setting)
2: Standard telegram 2, PZD-4/4
3: Standard telegram 3, PZD-5/9
4: Standard telegram 4, PZD-6/14
20: Standard telegram 20, PZD-2/6
350: SIEMENS telegram 350, PZD-4/4
352: SIEMENS telegram 352, PZD-6/6
353: SIEMENS telegram 353, PZD-2/2, PKW-4/4
354: SIEMENS telegram 354, PZD-6/6, PKW-4/4
999: Extend telegrams and change signal interconnection (Page 109)
7: Standard telegram 7, PZD-2/2
9: Standard telegram 9, PZD-10/5
110: SIEMENS telegram 110, PZD-12/7
111: SIEMENS telegram 111, PZD-12/12
999: Factory setting. See also Extend telegrams and change signal
interconnection (Page 109)
Configuring the fieldbus
7.3 Communication via PROFIBUS
93