Know-How Protection - Siemens SINAMICS G120D Original Instructions Manual

9.5.2

Know-how protection

Know-how protection
The know-how protection is used to encrypt configuring/engineering know-how, and protect it
against being changed or copied.
The settings of the converter are protected by a password.
If the password is lost, only default settings are possible.
The active know-how protection provides the following:
● All setting parameters are invisible.
● Parameters cannot be changed with a commissioning tool, e.g. operator panel or
● It is not possible to download the converter settings with the Starter or via a memory card
● It is not possible to use the trace function in the STARTER.
● Deleting the alarm history
● The STARTER dialog screens are disabled. The expert list in the STARTER contains
In the case of active know-how protection, support by technical support personnel is only
possible with the consent of the machine manufacturer.
Copy protection
In conjunction with the copy protection, the converter settings can be coupled only to a
single, pre-defined hardware.
The know-how protection with copy protection is possible only with the recommended
Siemens memory card; also see Section: Commissioning tools (Page 25)
Exception list
The active know-how protection permits an exception list for parameters to be defined that
the customer may access.
If you remove the parameter for the password from the exception list, the know-how
protection can only be undone by reverting to the factory settings.
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
STARTER.
only display parameters.
Backing up data and series commissioning
9.5 Write and know-how protection
269