Siemens SINAMICS G120D Original Instructions Manual page 121

Table 8- 3
Parameter
p1070 = 1050 Main setpoint
p1035
p1036
Adapting the behavior of the motorized potentiometer
Figure 8-9
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
Setting the MOP as setpoint source
Remark
Interconnecting the main setpoint with MOP.
Motorized potentiometer, setpoint higher
Motorized potentiometer, setpoint lower
Function chart of motorized potentiometer
Setting functions
8.3 Setpoints
Interconnect these commands with
signals of your choice.
121