Siemens SINAMICS G120D Original Instructions Manual page 193

Define analog signals for controlling
Procedure
To define the analog signals for controlling the traversing blocks, proceed as follows:
1. Change the signal source for the velocity override, if required.
You have now defined the analog signals for controlling the traversing blocks.
Define an external signal for block change
Precondition
You have selected the "External block change" button.
Procedure
To define an external signal for the block change, proceed as follows:
1. Specify whether the external signal is received via a fast digital input (probe) or from
2. To initiate a block change via the machine control system, you must interconnect this
3. Select the input with which cam signal 1 is interconnected.
4. Select the input with which cam signal 2 is interconnected.
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
The velocity override refers to the velocity values you have set in the screen for
programming the traversing blocks.
another source, e.g. via the fieldbus.
signal with a signal of your choice.
8.6 Basic positioner and position control
Setting functions
193