Factory Settings Of The Inputs And Outputs - Siemens SINAMICS G120D Original Instructions Manual

4.2.7

Factory settings of the inputs and outputs

Factory settings of the inputs and outputs of the CU250D-2 control unit
In the factory settings, the fieldbus interface of the inverter is not active.
Figure 4-11 Factory settings of the CU250D-2 control units
Changing the function of terminals
The function of every color-coded terminal can be set.
In order that you do not have to successively change terminal for terminal, several terminals
can be jointly set using default settings.
The factory setting of the terminals described above corresponds to the default setting 7
(switchover between fieldbus and a jog using DI 3).
See also: Default settings of inputs and outputs (Page 46).
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
Installation
4.2 Electrical Installation
45