HPE XP7 User Manual page 103

• If the command device being used for collection has authentication enabled, select the
Authentication Enabled check box. Enter the RWC user name and password that has privilege to
use the command device, and proceed to the next step to select the components. If you select
the same command device that was used for configuration data collection and if the
authentication was enabled for the configuration collection, the RWC credentials are automatically
populated in the fields adjacent to the Authentication Enabled check box.
• If you do not want to enable the authentication, proceed to the next step to select the
components.
NOTE: If authentication is required and you do not enable it, the performance data collection
fails.
6. In the respective component type lists, select the required check boxes for the components to collect
their performance data. The following component type lists are displayed:
7. You can set the frequency in minutes for the each of the following components: DKC, RAID groups,
and Port(s) in the respective Frequency list.
DKC
Port(s)
RG(s)
SNAP Group(s)
THP Group(s)
CA Journal Group(s)
External RG(s)
NOTE:
• The THP Group(s), CA Journal Group(s), and the SNAP Group(s) component type lists are
displayed only if the corresponding components are configured on the selected XP/XP7 disk
array. The External RG(s) component type list is displayed only if the external volumes are
attached to the selected XP/XP7 disk array.
• Selecting a ThP, snapshot, or a continuous access journal volume also provides the
respective volume pool information.
• To select all components, select the check box next to the component type.
8. To stagger the data collection time at different intervals, scroll down and select the Stagger
Collection check box.
For an XP disk array, the DKC provides data on the CHIPs,
ACPs, Cache, SLPR, CLPR, and the SM.
For an P9500/XP7 disk array, the DKC provides data on the MP
blades, in addition to the data on the Cache, CLPR, and the
SM.
Displays the frontend ports.
Displays the array volumes, including business copy and
continuous access (synchronous/asynchronous) volumes.
Displays the snapshot volumes.
Displays the ThP volumes.
Displays the continuous access journal volumes.
Displays the external RAID Groups connected to the selected
array.
Collection Schedules 103