Installation Guide
Installation of RP 95 S
NOTE! This instruction is for AK 95 S equipped with RP 95 S at delivery.
RP 95 S can also be ordered and installed as a kit, K23054. Refer to rebuilding instruction K23055.
Step 1
1. Loosen the two screws (with
black plastic knobs) under the
service tray holder.
2. Pull out the service tray holder
to its end position.
3. Loosen the two hexagonal
socket screws.
4. Remove the service tray holder
complete.
5. Fasten the hexagonal socket
screws again.
6. Attach the plug to the rear hole
of the stand and fasten the
screw (with black plastic knob).
Step 2
1. Put the RP 95 S unit into the front hole
of the stand. Fasten it with the attached
spacer and screw (∅ M4, 16mm)
2. Fasten the screw (with black plastic
knob).
1:6
2
1
G A M
B R O
G A M
B R O
4
3
M B
R O
G A M
B R O
AK 95 / AK 95 S Service Manual
HCEN 9133 Rev. 01. 2004
5
6