Gambro AK 95 S Service Manual page 54

Auto Heat disinfection
Auto Heat can be used with or without CleanCart. If the Auto Heat
shall be performed with CleanCart must the cartridge be installed
before the Auto Heat starts.
AK 95 S
With UFD
installed
Without
UFD
Temperature:
Note: The temperatures are verified at nominal values for the mains
voltage and at 20 °C ambient temperature.
Rinse/Drain:
Rinse/Drain
Drain
Exterior cleaning:
Note: Total Time for Disinfection Programs are estimated and may
vary.
Water supply
Flow rate:
Minimum inlet pressure:
Maximum inlet pressure:
Inlet temperature:
Connector in/outlet:
Quality:
H CEN9369 Revision.10.2005
Program version 12.xx
Disinfection programs
Heat
Heat CleanCart
Heat
Heat CleanCart
AK 95 S Service m anual - Technical data and spec ifi cations
Total Time [min]
230 V 110 V
31 35
43 49
31 35
43 48
+93 °C (measured after heating rod) ≥80
°C (measured in the outlet before the heat
exchanger)
10 minutes
4 minutes
All outside parts of the machine can
be cleaned with ethanol (70%) or
isopropanol (60%).
During treatment: maximum 770
ml/minDuring disinfection and
rinse/drain: a maximum flow rate of 800
ml/min is required.
0.12 MPa (1.2 bar)
0.6 MPa (6 bar)
Treatment: +5 to +30 ºC Disinfection:
+5 to +90 ºC
Diameter 8 mm
Inlet water quality must comply with
local regulations and if no such regulation
is available follow ISO 13959. Level
for conductivity shall not exceed 0.1
mS/cm. It is possible to use water with
higher conductivity if it consists mainly
of sodium salts. This may however affect
the accuracy of the fluid composition.
100 V
45
58
45
58
3:7