Gambro AK 95 S Service Manual page 239

3.3
1.
2.
3.
4.
5.
6.
7.
HCEN12190 Rev 05.2006
PET for AK 200 / AK 200 ULTRA / AK 200 S /
AK 200 ULTRA S
Check that the resistance between the grounding clips of the
mains plug and the power supply (right side, through the vent-
holes of the bottom box) is < 0.3 Ohm.
Check that the resistance between the grounding clips of the
mains plug and the FM bottom plate is < 0.3 Ohm.
Check that the resistance between the grounding clips of the
mains plug and the heater rods outside the heating vessel is <0.3
Ohm.
For 115 V machines: Also check that the resistance between the
grounding clips of the mains plug for the heater rods and the
heater rods outside the heating vessel is < 0.3 Ohm.
Check that the resistance between the grounding clips of the
mains plug and the overheat protection of the heater rods is
< 0.3 Ohm.
Check that the resistance between the grounding clips of the
mains plug and the potential equalization connector is
< 0.3 Ohm.
Check that the resistance between the grounding clips of the
mains plug and the heparin pump (rear plate) is < 0.3 Ohm.
Note! Don't measure on the cable clip or its binding screw.
Check that the resistance between the grounding clips of the
mains plug and the rear plate of the BVS-unit is < 0.3 Ohm.
Electrical Safety Inspections for AK-machines 11:5