Functional Check - Fch - Gambro AK 95 S Service Manual

Turn on the AK 95 S
The ON/OFF button on the Operators Panel is
used to turn the machine on and off.
The ON/OFF button must be pressed at least 3
sec. in order to switch the machine on and off.
The main switch on the power supply should
always be in ON position, even when the
machine is not in use. This "Stand by" mode is
indicated by a lit segment on the TIME display
on the operators panel.
If a power failure occurs when AK 95 S is work-
ing, the same segment in the TIME display is
flashing.
For further information about operating
instructions, please see:
AK 95 S Operator's Manual, HCEN 9794
or
AK 95 Operator's Manual, HCEN 9542.

Functional check - Fch

Each time the AK 95 is started, the automatic
functional check, Fch, is carried out.
The functional check will be aborted if Rinse/
Drain or any of the disinfection modes are
selected.
AK 95 / AK 95 S Service Manual
HCEN 9133 Rev. 01. 2004
h.min
Time
h.min
Time
Recommended start-up
procedure
First check:
• That the 9V battery is connected.
• That the mains cable is connected to power.
• That the main switch on the rear of the
monitor is turned on.
• That the machine is connected to the water
supply.
• That the drain tube is properly connected to
the machine and placed with an air gap between
the drain tube and the drain.
• That the dialysis fluid tubes are connected to
the safety couplings.
Start the machine
1. Press the ON/OFF button for 3 seconds.
2. Perform a Heat disinfection procedure accord-
ing to the Operator's Manual.
3. Perform a complete functional check accord-
ing to the Operator's Manual.
Installation Guide
1:9