Gambro AK 95 S Service Manual page 88

Service mode
In the Service mode it is possible to change
values and the status of both the hardware and
the software.
Before you enter the Service mode this is dis-
played:
MAINTENANCE SUPPORT SELECTION
Logging Service/Preset
Select Service/Preset, set the service code and
enter the Service mode.
Following displayshows up:
MAINTENANCE SELECTION
Fch
AK 95 / AK 95 S Service Manual
HCEN 9136 Rev. 10.2005
Preset Service
To step through the Service mode, use the Control
buttons as described below.
SET knob and SELECT key, to select.
HOLD key, to step backward.
Service Technicians Guide
4:15