Port Link-Type - HP 6125G Command Reference Manual

Layer 2 - lan switching
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

Configuring GigabitEthernet1/0/3... Done.
The output shows that GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 are
the member ports of the aggregation group corresponding to Bridge-Aggregation 1.

port link-type

Syntax
port link-type { access | hybrid | trunk }
undo port link-type
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
access: Configures the link type of a port as access.
hybrid: Configures the link type of a port as hybrid.
trunk: Configures the link type of a port as trunk.
Description
Use port link-type to configure the link type of a port.
Use undo port link-type to restore the default link type of a port.
By default, any port is an access port.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access.
After you change the link type of an interface with the port link-type command, the loopback detection
action configured on the interface with the loopback-detection action command automatically restores
the default. For more information about the loopback detection action configuration, see Layer 2—LAN
Switching Configuration Guide.
Examples
# Configure GigabitEthernet 1/0/1 as a trunk port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 and its member ports as hybrid ports.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
147

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents