no-control-word: Disables the control word option.
NOTE:
The HP 5800 switch series do not support the control word option.
Examples
# Create a static VC between CEs connected to different PEs.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] mpls static-l2vc destination 1.1.1.1 transmit-vpn-label 111
receive-vpn-label 222 tunnel-policy pol1
mtu (MPLS L2VPN view)
Description
Use the mtu command to set the maximum transmission unit (MTU) for the Kompella connections.
Use the undo mtu command to restore the default.
HP does not recommend using the mtu command, because it affects only possible protocol parameter
negotiations and does not instruct traffic forwarding.
Syntax
mtu mtu
undo mtu
View
MPLS L2VPN view
Default level
2: System level
Parameters
mtu-value: Specifies the MTU for the L2VPN. It ranges from 128 to 1500 and defaults to 1500.
Examples
# Set the MTU for Kompella connections to 1000.
<Sysname> system-view
[Sysname] mpls l2vpn vpn1
[Sysname-mpls-l2vpn-vpn1] mtu 1000
ping lsp pw (for MPLS L2VPN)
Description
Use the ping lsp pw command to check the validity and reachability of a Martini VC.
Syntax
ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m wait-time | -r reply-mode | -s packet-
size | -t time-out | -v ] * pw ip-address pw-id pw-id
262