Chapter 16 Got Self Check (Debug); Device Monitor Function; System Configuration - Mitsubishi Electric GOT SIMPLE Series User Manual

16
GOT SELF CHECK (DEBUG)
The debug includes functions to check the PLC system status and to improve troubleshooting efficiency.
The following is available as the debug.
Item
Device monitor
FX list editor
FX3U-ENET-ADP
communication setting function
16.1

Device Monitor Function

For a controller connected to the GOT, forcibly turning on or off devices of the controller and changing the set value or present
value are available.

System configuration

This section describes the controller names and connection types between the GOT and a controller that are applicable to the
device monitor function.
For details of communication units and cables for each connection type, refer to the following manual.
GOT2000 Series Connection Manual For GT Works3 Version1
Target controller
Controller
QCPU (Q mode)
QnACPU
FX CPU
Required system application
System application
Basic system application
Communication driver
Checking method of the version of basic system application and communication driver
Check the version of the basic system application and communication driver installed in the GOT at [System
Application Information] of the utility.
Refer to the following for details.
Page 163 OS information
Description
For a controller connected to the GOT, forcibly turning on or off devices of the
controller and changing the set value or present value are available.
The sequence program of FX PLC can be edited.
The communication set value of the FX3U-ENET-ADP stored in the CPU can be
changed.
Connection type
Direct CPU connection, Computer link connection, CC-Link(G4) connection
Direct CPU connection, Computer link connection
Direct CPU connection
MELSEC-Q/L/QnA
MELSEC-FX
CC-Link(G4)
Reference
Page 219 Device Monitor Function
Page 232 FX List Editor
Page 261 FX3U-ENET-ADP
Communication Setting Function
Version
-
-
-
-
16 GOT SELF CHECK (DEBUG)
16.1 Device Monitor Function
16
219