Test Pattern Printing - Ricoh M0A0 Service Manual

5.System Maintenance

Test Pattern Printing

Printing Test pattern: SP2-109
Some of these test patterns are used for copy image adjustments but most are used primarily for design testing.

Do not operate the machine until the test pattern is printed out completely. Otherwise, SC will occur.
1.
Enter the SP mode.
2.
Press SP2-109-001.
3. Select a test pattern from the list, and then press [OK].
4.
To change the density of the test pattern, select the density with SP2-109-002, then press [#].
 If the value of SP2-109-002 is 0, the color adjusted so will not show up in the test pattern.
5.
To print, press [Copy Window], and then make settings within the copy window for the test print (paper size etc...).
6. Press [Start] to start the test print.
7.
After checking the test pattern, press [SP Mode] on the screen to return to the SP mode display.
8.
Reset all settings to the default values with SP2-109-003 and SP2-109-006.
9.
Exit SP mode.
No.
0 None
1 Vert. (1dot)
2 Hori. (1dot)
3 Vert. (2dot)
4 Hori. (2dot)
5 Grid Vert.
6 Grid Hori.
7 Grid 20mm
192
Pattern
8
9
10
11
12
13
14
15
No.
Arg. Grid
Arg.Grid20mm
Indep.(1dot)
Indep.(2dot)
Indep.(4dot)
Full
Band
Trim Area
Pattern