Ricoh M0A0 Service Manual page 617

Error codes
The meanings of error codes recorded after "error:" in the result file are as follows:
Error codes recorded during firmware update
Error code
-2 Invalid file
-3 The target application cannot be found.
-501 Installation has already been requested.
-602 Invalid signature
-603 Updating is prohibited.
-604 Failed to put the application offline.
-610 Authentication failed.
-699 Unknown error
-701 Version of the micro computer firmware is invalid.
-709 File structure error (invalid file)
-710 Writing failure
Error codes recorded during application update
Error code
-2 Invalid file
-3 The target application cannot be found.
-4 The storage capacity is not enough.
-12 The version of the Android application cannot be installed.
-602 Invalid signature
-603 Updating is prohibited.
-604 Failed to put the application offline.
-610 Authentication failed.
-699 Unknown error
*1 The error code recorded in the Access Log will be "223: machine-busy".
*2 If the error occurs during preparation for configuration change, it will not be recorded in the Access Log.

If the preparation for configuration change (putting the application offline, authentication, file size check)
cannot be carried out, an error code is displayed on the screen. However, it is not recorded in the Access Log
as a firmware update/installation error.
Error codes recorded in the Access Log
Error Error name
code
49 fwu-prohibit
Explanation
Explanation
Explanation
Firmware update is prohibited.
4.Troubleshooting
Recorded
Recorded
Recorded (*1)
Recorded
Recorded
Not recorded
Not recorded
Recorded (*2)
Recorded
Recorded
Recorded
Recorded
Recorded
Recorded
Recorded
Recorded
Recorded
Not recorded
Not recorded
Recorded (*2)
Solution
Enable firmware update, and repeat the
Access Log
Access Log
59