Ricoh M0A0 Service Manual page 657

Check Point
8 Transmission sent manually?
9 IP address of local fax registered?
10 DNS registered when host name specified?
11 Remote fax a G3 fax?
12 G3 fax is connected to VoIP gateway?
13 Remote G3 fax turned on?
14 Network bandwidth too narrow?
Cannot send by Alias Fax number
1 LAN cable connected?
2 Number of specified Alias fax correct?
3 Firewall/NAT installed?
4 Transmission sent manually?
5 Gatekeeper/SIP server installed correctly?
6 Gatekeeper/SIP server power switched on?
7 IP address/host name of Gatekeeper/SIP server
correct?
8 DNS server registered when Gatekeeper/SIP server
host name specified?
9 Enable H.323/Enable SIP SW is set to on?
10 IP address of local fax registered?
11 Alias number of local fax registered?
12 Remote fax registered in Gatekeeper?
13 Remote fax a T.38 terminal?
14 Remote fax switched off or busy?
15 Network bandwidth too narrow?
Check Point
(Fax, Internet Fax)
Manual sending not supported.
Register the IP address.
Contact the network administrator.
Check that the remote fax is a G3 fax.
Check that G3 fax is connected.
Check that G3 fax is switched on.
Request the network administrator to increase the
bandwidth.
Raise the network delay level.
IPFAX SW 01 Bit 0 to 3
IP-Fax bandwidth is the same as the DCS speed. Set IP-Fax
SW00 Bit 6 to 1.
Check the LAN cable connection.
Confirm the Alias of the remote fax.
Error Code: 13-14
Cannot breach the firewall. Send by using another
method (Fax, Internet Fax)
Manual sending not supported.
Contact the network administrator.
Contact the network administrator.
Check the IP address/host name.
Contact the network administrator.
Check the settings.
See User Parameter SW 34 Bit 0/SW 34 Bit 1
Register the IP address of the local fax.
Register the Alias number of the local fax.
Contact the network administrator.
Check whether the remote fax is a T38 terminal.
Contact the network administrator.
Request the system administrator to increase the
bandwidth.
3.Troubleshooting
Action
Action
31