Table of Contents
Advertisement
(3) Administrator login password
If any of these settings is at a factory default, ask the customer to change the settings before you perform the
installation procedure.
2.
Make sure that "Machine Management" is ON.
[User Tools/Counter] key -> [System Settings] -> [Administrator Tools] -> [Administrator Authentication
Management] -> [Machine Management] -> [On]
If this setting is OFF, ask the customer to change the setting to ON before you perform the installation procedure.
3.
Make sure that "Administrator Tools" is enabled (selected).
[User Tools/Counter] key -> [System Settings] -> [Administrator Tools] -> [Administrator Authentication
Management] -> [Machine Management] -> [On] -> [Select available settings] -> [Administrator Tools]
If this setting is disabled (not selected), ask the customer to enable (select) the setting before you perform the
installation procedure.
Installation Procedure
1.
Connect the network cable if necessary.
2.
Turn ON the main power.
3.
Enter the SP mode.
4.
Execute SP5-878-001.
5.
Exit the SP mode and turn OFF the main power.
6.
Turn ON the power.
7.
Execute SP5-990-005 (SP print mode Diagnostic Report).
8.
Enter the User Tools mode, and select [System Settings] - [Administrator Tools] - [Auto Erase Memory Setting] -
[On].
9.
Exit the User Tools mode.
Using Auto Erase Memory
The Auto Erase Memory function can be enabled by the following procedure.
1.
Log in as the machine administrator from the control panel.
2.
Press [System Settings].
3.
Press [Administrator Tools].
4.
Press [ ] to display Page 9.
2.Installation
83
Advertisement
Chapters
Table of Contents
Troubleshooting
