Ricoh M0A0 Service Manual page 672

4.Service Tables
0-7 Threshold memory level for parallel memory transmission
System Switch 11 (SP No. 1-101-018)
No Function
0 TTI printing position
0: Superimposed on the page data
1: Printed before the data leading
edge
1- Not used
2
3 TTI used for broadcasting
0: The TTIs selected for each
Quick/Speed dial are used
1: The same TTI is used for all
destinations
4- Not used
7
System Switch 12 (SP No. 1-101-019)
No Function
0- TTI printing
7 position in the
main scan
direction
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 (SP No. 1-101-022)
No Function
0 Not used
1 Going into the Energy Saver mode
automatically
0: Enabled
46
Comments
Change this bit to 1 if the TTI overprints information that the customer
considers to be important (G3 transmissions).
NOTE: If "1" is selected, it is possible that sent data is printed on two
sheets of paper.
Do not change these settings.
1: The TTI (TTI_1 or TTI_2) which is selected for all destinations during
broadcasting.
Do not change these settings.
Comments
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the TTI from the left edge of the paper. If
the TTI is moved too far to the right, it may overwrite the file number which is on the top
right of the page. On an A4 page, if the TTI is moved over by more than 50 mm, it may
overwrite the page number.
Comments
Do not change the settings.
1: The machine will restart from the Energy Saver mode quickly,
because the +5V power supply is active even in the Energy Saver
mode. The LED of the operation switch is flashing instead of
Threshold = N x 128 KB + 256 KB
N can be between 00 - FF(H)
Default setting: 02(H) = 512 KB