Position-Speed Switching Control - Mitsubishi Electric QD75P1N User Manual

9 MAJOR POSITIONING CONTROL
Position-speed switching control start
Position-speed switching
signal
Cd.25
Position-speed switching
latch flag
Md.31
Stop signal
Changing the speed control command speed
In "position-speed switching control", the speed control command speed can be
changed during the position control.
(1) The speed control command speed can be changed during the position control
of position-speed switching control.
A command speed change request will be ignored unless issued during the
position control of the position-speed switching control.
(2) The "new command speed" is stored in " Cd.25 Position-speed switching
control speed change register" by the sequence program during position
control.
This value then becomes the speed control command speed when the
position-speed switching signal turns ON.
OFF
Position-speed
0
switching control
speed change register
ON
Status: b5
OFF
Fig. 9.20 Speed control speed change timing
Position Speed
control control
Speed change
enable
ON
V2 V3
V2 becomes the speed control command speed.
OFF
ON
9 - 127
Position control start
Setting after the position-speed
switching signal ON is ignored.
MELSEC-Q
t