Mitsubishi Electric QD75P1N User Manual page 113

5 DATA USED FOR POSITIONING CONTROL
: Always set, : Set as required,
–: Setting not required (This is an irrelevant item, so the set value will be ignored. If the value is the default value or within the setting range, there is no
problem.)
1: Two control systems are available: the absolute (ABS) system and incremental (INC) system.
2: Set the M code for the reference axis and the number of pitch for the linear interpolation axis.
: Setting not possible
Checking the positioning data
The items Da.1 to Da.10 are checked at the following timings:
(1) Startup of a positioning operation
(2) Error check performed by GX Configurator-QP
5 - 9
MELSEC-Q