Mitsubishi Electric QD75P1N User Manual page 596

12 CONTROL SUB FUNCTIONS
(3) Since the upper/lower limit values of the positioning address calculated are
outside of the range of Condition 2, use the positioning address within the
positioning range of Condition 2 (-214748364.8(m) to 214748364.7(m)).
-241591910.4 -214748364.8
Setting disallowed
2. Concept for the unit of degree
 The positioning address is within the range 0 to 359.99999 at the position
to which a machine OPR was made.
When the OP position is not 0, the range is also 0 to 359.99999.
 For positioning in the same direction, control from maximum to minimum
(for address increase: 359.99999 to 0/for address decrease: 0 to
359.99999) cannot be exercised. (See below)
359.99999
0
Unusable in absolute position detection
system.
Current value cannot be restored
properly at power supply on or resetting
 When positioning is to be used in the absolute position detection system,
set the upper/lower limit values of the software stroke limit within the range
0 to 359.99999.
OP
0
Usable range in absolute
position detection system
OP
359.99999
0
Usable range in absolute position detection system
( ~
0
12 - 72
214748364.7
Setting disallowed
Unusable in absolute position
detection system.
Current value cannot be restored
properly at power-on or reset.
)
359.99999
MELSEC-Q
Unit: m
241591909.5