Mitsubishi Electric QD75P1N User Manual page 798

APPENDICES
Appendix 10.2 Setting parameters
Set parameters for the positioning module.
By setting parameters, the parameter setting by sequence program is not needed.
Parameter setting
(1) Operating procedure
1. Open the "Parameter" window.
Project window
"Parameter"
2. Configure settings
Double-click the setting-target item and select or enter a value.
 Items with a pull-down list
Double-click the item and select an item in the displayed pull-down list.

Items without a pull-down list
Double-click the item and enter a value.
For details on the setting items, refer to the following.
Parameter
Basic parameters 1
Basic parameters 2
Detailed parameters 1
Detailed parameters 2
OPR basic parameters
OPR detailed parameters
[Intelligent Function Module]
Reference
Section 5.2.1
Section 5.2.2
Section 5.2.3
Section 5.2.4
Section 5.2.5
Section 5.2.6
Appendix - 82
MELSEC-Q
Module name