Vcm Video Encoding Functionality; Overview; Functional Description For Vcms - Ericsson AVP 4000 Reference Manual

Advanced Video Processing and Networking
Table 6.1 IP Overhead
Item
MPEG-2 TS
UDP
IP
Ethernet
Total overhead factor becomes: 1.006 x 1.015 x 1.010 = 1.031 or 3.1% overhead.
Note: The number of MPEG-2 TS packets one can map down into each UDP
6.2

VCM Video Encoding Functionality

6.2.1.1

Overview

The VCMs process the video input signal into a compressed encoded bit stream in
accordance with the appropriate specification (ITU-T H.264 or ISO/IEC MPEG-4
AVC, MPEG-2 specification (ISO/IEC 13818) or JPEG 2000 specification (ITU-T
Rec. T.802 or ISO/IEC 15444-3)).
6.2.1.2

Functional Description for VCMs

Figure 6.4 VCM Functional Diagram
The 3G/HD/SD-SDI Video Input can be configured to accept either 25 Hz or
29.97 Hz video. The Pre-processor has a video frame re-synchronizer which allows
the video frame rate to be locked to the Unit 27 MHz clock, or to a 27 MHz clock
locked to an external sync input if an External Sync Input option card
(AVP/HWO/EXTSYNC) is fitted. If the unit is configured to be locked to video, then
the frame re-synchronizer is inactive.
The Pre-processor can perform horizontal and vertical scaling and bandwidth
filtering on the video prior to passing it on to the Video Encoder. It can also generate
a test pattern or repeat the last frame received if the video input is not valid.
The Video Encoder processes the video from the Pre-processor into a compressed
encoded bit-stream in accordance with the relevant specification.
It can produce a constant bit rate (CBR) output, which can be set in the range
1 Mbps to 200 Mbps depending upon encoder and profile.
6-8
Overhead factor
1.0
1324/1316 = 1.006
1344/1324 = 1.015
1358/1344 = 1.010
frame is variable (between 1 and 7). Usually 7 is used for minimum
overhead. This is also used in the above calculation.
Comments
UDP header=8 bytes
IP header=20 bytes
Eth header=14 bytes
1/1553-FGC 101 1790 Uen Y