Monitoring Switch Setup Configuration - Cisco Catalyst 2960 series Configuration Manual

DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
copy running-config startup-config
Example:
copy running-config startup-config
Step 3
reload in [hh:]mm [text]
Example:
Switch(config)# reload in 12
System configuration has been
modified. Save? [yes/no]: y
Step 4 reload at hh: mm [month day | day month]
[text]
Example:
Switch(config)# reload at 14:00
Step 5 reload cancel
Example:
Switch(config)# reload cancel
Step 6
show reload
Example:
show reload

Monitoring Switch Setup Configuration

Example: Verifying the Switch Running Configuration
Switch# show running-config
Building configuration...
Purpose
Enters global configuration mode.
Saves your switch configuration information to the startup configuration
before you use the reload command.
Schedules a reload of the software to take affect in the specified minutes
or hours and minutes. The reload must take place within approximately
24 days. You can specify the reason for the reload in a string up to 255
characters in length.
Specifies the time in hours and minutes for the reload to occur.
Note
Cancels a previously scheduled reload.
Displays information about a previously scheduled reload or identifies
if a reload has been scheduled on the switch.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Monitoring Switch Setup Configuration
Use the at keyword only if the switch system clock has been
set (through Network Time Protocol (NTP), the hardware
calendar, or manually). The time is relative to the configured
time zone on the switch. To schedule reloads across several
switches to occur simultaneously, the time on each switch
must be synchronized with NTP.
1583