Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch> enable
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 errdisable detect cause small-frame
Example:
Switch(config)# errdisable detect cause
small-frame
Step 4 errdisable recovery interval interval
Example:
Switch(config)# errdisable recovery interval
60
Step 5 errdisable recovery cause small-frame
Example:
Switch(config)# errdisable recovery cause
small-frame
Step 6 interface interface-id
Example:
Switch(config)# interface
gigabitethernet1/0/2
Step 7 small-frame violation-rate pps
Example:
Switch(config-if)# small-frame violation rate
10000

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.
Enables the small-frame rate-arrival feature on the switch.
(Optional) Specifies the time to recover from the specified
error-disabled state.
(Optional) Configures the recovery time for error-disabled
ports to be automatically re-enabled after they are error
disabled by the arrival of small frames
Storm control is supported on physical interfaces. You can
also configure storm control on an EtherChannel. When storm
control is configured on an EtherChannel, the storm control
settings propagate to the EtherChannel physical interfaces.
Enters interface configuration mode, and specify the interface
to be configured.
Configures the threshold rate for the interface to drop
incoming packets and error disable the port. The range is 1 to
10,000 packets per second (pps)
How to Configure Port Security
1499