Configuring 802.1X Authentication With Downloadable Acls And Redirect Urls - Cisco Catalyst 2960 series Configuration Manual

How to Configure 802.1x Port-Based Authentication
Command or Action
Step 13
show running-config interface interface-id
Example:
Switch# show running-config interface
gigabitethernet1/0/1
Step 14
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 15 Configuring NEAT with Auto Smartports Macros

Configuring 802.1x Authentication with Downloadable ACLs and Redirect URLs

In addition to configuring 802.1x authentication on the switch, you need to configure the ACS. For more
information, see the Configuration Guide for Cisco Secure ACS 4.2:
http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2/configuration/guide/acs_config.pdf
Note You must configure a downloadable ACL on the ACS before downloading it to the switch.
After authentication on the port, you can use the show ip access-list privileged EXEC command to display
the downloaded ACLs on the port.
Configuring Downloadable ACLs
The policies take effect after client authentication and the client IP address addition to the IP device tracking
table. The switch then applies the downloadable ACL to the port.
Beginning in privileged EXEC mode:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1400
Purpose
Verifies your configuration.
(Optional) Saves your entries in the configuration file.
You can also use an Auto Smartports user-defined macro
instead of the switch VSA to configure the authenticator
switch. For more information, see the Auto Smartports
Configuration Guide for this release.