Environment Variables For Tftp - Cisco Catalyst 2960 series Configuration Manual

Information About Performing Switch Setup Configuration
Variable
CONFIG_FILE
SWITCH_NUMBER
SWITCH_PRIORITY
BAUD
ENABLE_BREAK

Environment Variables for TFTP

When the switch is connected to a PC through the Ethernet management port, you can download or upload a
configuration file to the boot loader by using TFTP. Make sure the environment variables in this table are
configured.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1568
Boot Loader Command Cisco IOS Global Configuration Command
set CONFIG_FILE boot config-file flash:/ file-url
flash:/ file-url
Specifies the filename that Cisco IOS uses to
Changes the filename read and write a nonvolatile copy of the system
that Cisco IOS uses to configuration. This command changes the
read and write a CONFIG_FILE environment variable.
nonvolatile copy of the
system configuration.
set switch current-stack-member-number
SWITCH_NUMBER renumber new-stack-member-number
stack-member-number
Changes the member number of a stack
Changes the member member.
number of a stack
member.
set switch stack-member-number priority
priority-number
SWITCH_PRIORITY
stack-member-number
Changes the priority value of a stack member.
Changes the priority
value of a stack
member.
set BAUD baud-rate
line console 0
speedspeed-value
Configures the baud rate.
set boot enable-break switch yes/no
ENABLE_BREAK
This command can be issued when the flash
yes/no
filesystem is initialized when
ENABLE_BREAK is set to yes.