Table of Contents
Advertisement
Figure 40. Server cover removal
Attention: For proper cooling, always install the server cover before powering on the server.
Operating the server without the cover properly installed might result in server component damage.
a.
Use the key attached on the rear of the server to turn the cover lock to the unlocked
position.
b.
Slide the server cover towards the rear of the server until the server cover is disengaged
from the chassis. Then, lift the server cover off the chassis and place it on a flat clean surface.
Remove the front bezel
Use this information to remove the front bezel.
About this task
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
ThinkSystem ST650 V2 Setup Guide
86
Advertisement
Table of Contents
