Mitsubishi Electric GOT2000 Series User Manual page 246

(2) Mounting on the panel face (When setting the connector for Handy GOT connection and the
power supply switch on the panel surface)
Step 1.
Drill a mounting slot of the following size on the panel face.
Step 2.
Install the Connector Conversion Box on the panel face.
Tighten the mounting screw within the specified torque range (0.69 N•m to 0.88 N•m).
Tightening screws too much may cause damage.
7 - 6
7.1 Connector Conversion Box
43±0.2
(1.69±0.01)
Drill 4- 5±0.5 (0.2±0.02)
Panel cut area
Unit: mm (inch)
M4 screw and nut
4- 4.5 (0.18)
× 4 sets
(prepared by user)
43 (1.7) 6 (0.24)
ON
OFF
Unit: mm (inch)