Emergency Stop Switch Guard Cover; Applicable Emergency Stop Sw Guard Cover; Installing Procedure - Mitsubishi Electric GOT2000 Series User Manual

7.2

Emergency Stop Switch Guard Cover

The emergency stop SW guard cover is attached to prevent the emergency stop SW from being operated incorrectly.
7.2.1

Applicable emergency stop SW guard cover

The following emergency stop SW guard cover is applicable for the Handy GOT.
Product name
Emergency stop SW guard cover
7.2.2

Installing procedure

Step 1.
Remove the Handy GOT from the device or turn the entire system power off.
Make sure that the system is not affected even if the emergency stop switch of the Handy GOT is activated
while mounting the emergency stop SW guard cover.
Step 2.
Fit the screw hole of the emergency stop SW guard cover to the mounting hole of the emergency stop SW
guard cover of the Handy GOT.
Tighten them with the accessory screw (M3×6) within the specified torque range (0.36 N•m to 0.48 N•m).
Too much tightening may cause damage.
Model name
GT16H-60ESCOV Mounting screw (M3×6)×1 (accessory)
Contents
7.2 Emergency Stop Switch Guard Cover
7
7 - 19