6.4.5
GT21
Depending on the units and cables used for the GOT, the distance more than the described dimensions may be required.
Install the GOT with consideration of the connector dimensions and the cable bend radius.
For the cable pull-out distance from the bottom of the GOT, refer to the following.
➠
For the vertical installation, install the GOT so that the power supply terminal, which is located on the GOT rear face, is at
the lower side.
➠
Horizontal
C
Vertical
A
6 - 24
6.4 Installation Position
13.1 External Dimension Diagrams
4.6 GT21
B
A
D
D
Panel thickness: 1 mm to 4 mm (0.06 to 0.16 inch)
B
Panel thickness: 1 mm to 4 mm (0.04 to 0.16 inch)
E
E