Mitsubishi Electric GOT2000 Series User Manual page 243

Item
Keylock switch
1A/24VDC(resistance load)
(2-position switch)
0.3A/24VDC(induction load)
KSWC, KSW1, KSW2
*1 The system may not match the safety standards.
Before using the system, please check the safety standards which are required.
■2. Part name and External dimensions (GT16H-CNB-42S)
2)
5)
Item Specifications
1) Connector for Handy GOT(42pin,female type)
2) Power switch
3) POWER LED
4) Hole for the panel installation
5) Packing attachment chase
6) Hook for DIN rail
7) Hole for the screw installation
8) Terminal block 1
9) Terminal block 2
External connection device communication
connector (RS-232: D-Sub 9pin male)
10)
connector model name: JES-9P-2A3A (JST) or
equivalent
External connection device communication
connector (RS-422/485: D-Sub 9pin female)
11)
connector model name: 17JE-13090-37D23A
(DDK) or equivalent
External connection device communication
12)
connector (Ethernet: RJ-45 module jack)
Contact rating
Each contact coordinates the position of the keylock switch.
• When the key is on the left: KSW1 and KSWC are short-circuited.
• When the key is on the right: KSW2 and KSWC are short-circuited.
When the external cable is not connected, contacts are always open regardless of the keylock
switch.
3) 4)
1)
12)
Connects a Handy GOT through an external cable.
Supplies the power to the Handy GOT.
When this switch is set to ON, the power is supplied.
Turn off the power when attaching or detaching the Handy GOT.
Lit in green: Power is correctly supplied.
Not lit: Power is not supplied.
Used when mounting the panel. For M4 screw, depth 6mm
Used when mounting the panel.
Used for fixing the Connector Conversion Box when mounting DIN rail (35mm).
Used for fixing on the board, etc. For M4 screw
Connects the GT16H-CNB-42S, the 24VDC power supply of Handy GOT and the emergency stop
switch (ES-1 to 3) with M3 terminal screw and the cover.
Connects the operation switch of the Handy GOT (SW1 to 6), the grip switch (DSW-1, 2) and the
keylock switch (KSW-1, 2) with M3 terminal and the cover
Connects to the external connection device.
RS-232 connector and RS-422/485 connector cannot be used at the same time.
Connects the external connection device via Ethernet with using a LAN cable.
Specifications
Terminal block cover opened
8)
13)
15)
ON
OFF
10)
11)
10BASE-T
100BASE-TX
7)
6)
7.1 Connector Conversion Box
ES1A ES1B ES2A ES2B ES3A ES3B FG
ES1A ES1B ES2A ES2B ES3A ES3B - INPUT 24VDC +
14)
ID No.
U L
RS-232
RS-422
SW-COM SW2 SW4 SW6 KSW1 DSW1 DSW2
SW1 SW3 SW5 KSW-COM KSW2 DSW1 DSW2
16)
9)
Weight: about 0.5kg
7
7 - 3