Grip Switch; Grip Switch Wiring - Mitsubishi Electric GOT2000 Series User Manual

Graphic operation terminal

Hide thumbs Also See for GOT2000 Series:

Table of Contents

Grip switch

The grip switch is on the side surface of the Handy GOT and wired to the input of PLC, etc.

The grip switch is the 3-position system switch and makes the ON/OFF state of Handy GOT as shown below.

The grip switch is a switch with two circuits of the above 3-position system a contact.

■1. Connection example

Set the load up to 24VDC/1A (contact specification) for each contact.

■2. Pin layout

Connector Conversion Box

Side surface of grip switch

When released

When half-pressed

conversion box

Terminal block 2

When fully pressed

Terminal No.

Terminal block 2

9.4 Switch Wiring

Used as input

signals of PLC

Used as control

external device

power ON/OFF

Terminal block 2