Mitsubishi Electric GOT2000 Series User Manual page 188

Step 8.
Peel off the remainder of the release paper, and attach the whole environmental protection sheet to the
control panel.
Make sure to attach the sheet from the attached part in step 7, and fit the sheet onto the control panel
without leaving any air between them.
Step 9.
Erase the markings.
Step 10.
Apply enough pressure to the adhesive part of the environmental protection sheet.
(Roll a roller back and forth two times with a load of 2 kg.)
To ensure adequate adhesive strength, you are recommended to use the GOT about 24 hours later after
the environmental protection sheet is attached.
Check that the environmental protection sheet has no wrinkle, dirt, or others, and then remove the
protective film from the sheet.
6 - 36
6.6 Installing the GOT
Environmental
protection sheet
Remainder of the
release paper
Marking
protection sheet
Environmental
protection sheet