Step 1.
Install the supplied fittings on the top and bottom of the GOT with screws.
Each fitting has two types of holes as shown below.Use the appropriate type of holes according to the
control panel thickness.
Hole A: for the control panel thickness 1.5 mm to 3.0 mm
Hole B: for the control panel thickness 2.0 mm to 4.0 mm
When installing the fittings on the GOT, you are recommended to put a cloth or others under the GOT to
prevent the display section from being damaged.
Step 2.
Align the installation holes of the fittings with the studs, and insert the studs in the holes.
1.5
3.0
Hole A Hole B
GOT
Fittings
Fittings (Top: 1, bottom: 1)
Screws (Top: 3, bottom: 3)
Cloth
2.0
4.0
Stud
panel opening
6.6 Installing the GOT
6
6 - 33