Configuring Automatic Dialing - AudioCodes Mediant 1000 User Manual

User's Manual
27.5

Configuring Automatic Dialing

The Automatic Dialing table lets you configure telephone numbers that are automatically
dialed when FXS or FXO ports go off-hook. The dialing can be done immediately upon off-
hook or after a user-defined interval after off-hook, referred to as Hotline dialing. For
example, you can configure Hotline automatic dialing where if Port #1 remains off-hooked
for over 15 seconds, the device automatically dials 911.
The following procedure describes how to configure automatic dialing upon off-hook
through the Web interface. You can also configure it through ini file (TargetOfChannel) or
CLI (configure voip > gateway analog automatic-dialing).

To configure automatic dialing per port:
1. Open the Automatic Dialing table (Setup menu > Signaling & Media tab > Gateway
folder > Analog Gateway > Automatic Dialing).
2. Select the row corresponding to the port that you want to configure, and then click
Edit; the following dialog box appears:
3. Configure automatic dialing per port according to the parameters described in the
table below.
4. Click Apply.
Table 27-2: Automatic Dialing Table Parameter Descriptions
Parameter
Index
[TargetOfChannel_Index]
Module
[TargetOfChannel_Module]
Port
port
[TargetOfChannel_Port]
Port Type
[TargetOfChannel_PortType]
Destination Phone Number
Version 7.2
(Read-only) Displays the index number of the table row.
(Read-only) Displays the module number on which the
port is located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (FXS or FXO).
Defines the destination telephone number to automatically
dial.
581
27. Analog Gateway
Description
Mediant 1000B Gateway & E-SBC