Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
Restoring the System Configuration Settings
To restore the system configuration settings from a backup:
1. Verify that the FTP service is running on the host workstation.
2. Log in to the switch as the admin user.
3. Shut down the switch by entering the following command:
4. At the command line enter the following command:
Note:
5. Reboot the switch by entering the following command:
86
switchDisable
hostIPaddr
configDownload "
The hostIPaddr is the IP address of the host computer, user is the User ID for
this computer, path_filename is the path location of the configuration file, and
password is the password for the user ID specified.
The password operand is only required if you are using FTP.
fastBoot
user
path_filename
", "
", "
Core Switch 2/64 V4.1 Installation Guide
password
","
"
Advertisement
Table of Contents
