Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
Connecting SFPs
Use these steps to connect SFPs (Small Form Factor Pluggable) to the Fibre
Channel ports as required. Purchase SFPs separately. For purchasing information,
refer to
Note:
trunking groups: four ports marked with black solid ovals alternate with four ports
marked with oval outlines.
Note:
1. Position one of the SFP transceivers so that the key is oriented correctly to the
82
Table 3
in the section
The ports are color-coded to indicate which ones can be used in the same
The ports and cables used in trunking groups must meet specific requirements.
Caution:
Do not route cables in front of the exhaust vent (located at the top of
the port side of the chassis).
port, and insert the transceiver into the port until it is firmly seated and the
latching mechanism clicks. See
Optional Hardware Kits
Figure
21.
Core Switch 2/64 V4.1 Installation Guide
in
Chapter
1, on page 30.
Advertisement
Table of Contents
