Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
Connecting the Core Switch 2/64 to the LAN
Use these steps to connect the active CP card to an Ethernet connection.
1. Remove the shipping plug from the Ethernet port on the active CP card.
2. Insert one end of an Ethernet cable into the CP card's Ethernet port.
3. Connect the remaining end to an Ethernet 10/100 Base-T LAN.
Note:
available management tools, such as telnet or Web Tools. Ensure that the switch is not
modified from other connections during the rest of this procedure. You can complete
the remaining steps in this procedure through either the serial session or a telnet
session.
4. Log on to either of the logical switches by telnet, using the administrative
5. Customize the switch names for the logical switches, as follows.
Note:
name causes a domain address RSCN format to be issued.
80
The switch can now be accessed by remote connection using any of the
logon. (The default administrative logon name is admin and the default
password is password.)
HP recommends using the default switch names if possible. Changing the switch
a. Enter the command switchName with the new name in quotes as
follows (sw10 is an example name):
switchName "sw10"
b. Record the new switch name for future reference.
c. Customize the switch name for the other logical switch:
— Logout of the CP session
— Connect the serial cable to the other CP card
— Log in as Admin
— Repeat steps 5a through 5b for the other logical switch.
Core Switch 2/64 V4.1 Installation Guide
Advertisement
Table of Contents
