Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
For Rails with Round Holes—Attaching the Clip Nuts
If installing the 14U Rack Mount Kit in rails with round holes, refer to this
section. Attach the clip nuts to the vertical rails on the service side of the rack as
follows.
1. Count up 41 round holes from the 1U location.
2. Attach the four clip nuts to the two rails at the front of the rack (service aisle
Note:
holes in the sides of the chassis. If the cables will be routed down through the cable
management tray, allow adequate space below the chassis for cable management.
Attaching the Upper Rack Mount Bracket Assemblies to the Chassis
Use these steps to attach the upper rack mount brackets to the chassis. The upper
rack mount bracket assemblies consist of the following:
Note:
upper rack mount bracket assemblies.
1. Use a Phillips head screwdriver to remove the screws securing the left and
Note:
2. Save the screws for attaching the bracket assemblies to the chassis (see
54
Use the clip nuts for rails with round holes only.
Refer to the section
For Rails with Square Holes—Attaching the Retainer
Nuts, on page 53 if installing the switch in rack rails with square holes.
side). See
Figure
7.
Cables can be routed down through the cable management tray or through the
One right flat upper rack mount bracket attached to an L-shaped bracket
One left flat upper rack mount bracket attached to an L-shaped bracket
To compete this procedure, you must first detach the L-shaped brackets from the
right upper rack mount brackets to the L-shaped brackets. Detach the
L-shaped brackets from the assembly, and put them aside.
You reinstall the L-shaped brackets to the rack rails in
in the section
Securing the Chassis to the Rails
step
5.
on page 58).
Core Switch 2/64 V4.1 Installation Guide
step 1
Advertisement
Table of Contents
