Table of Contents
Advertisement
Replacing a Filler Panel or CP Card
Use these steps to remove a filler panel or CP card.
1. If removing a filler panel, push the yellow button on each ejector in, open
2. If removing a CP card, first determine which CP card is the active CP card as
Note:
standby CP card. The standby CP card is now the active CP card.
3. Disconnect the following cables, if present:
Core Switch 2/64 V4.1 Installation Guide
Caution:
Wear an ESD grounding strap when handling a CP card. The
chassis provides a grounding connection above the power connectors. Hold
the CP card by the edges of the metal pan (not by the ejectors).
both ejectors all the way, and slide the filler panel out of the chassis.
follows:
a. Log onto the switch from a terminal emulator application, (such as
HyperTerminal on Windows systems, or TERM in a Unix or Linux
environment).
b. Configure terminal emulator settings. Refer to the "Setting Network
Addresses via a Network Connection" section in chapter 2 for correct
values.
c. Enter haShow at the prompt.
d. If the card you are replacing is the:
— Standby CP card, continue with step 2.
— Active CP card, type haFailover at the prompt. This command
causes the two CP cards to switch roles, (that is, the standby CP card
becomes the new active CP card).
The haFailover command causes the active CP card to failover to the
a. Modem cable from the modem serial port
b. Serial cable from the terminal serial port
c. Ethernet cable from the Ethernet port
Installing Core Switch 2/64 FRUs
139
Advertisement
Table of Contents
