Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
5. Attach the two L-shaped brackets to the rack rails farthest from the service
6. Route any cables or cords through the cabinet or along any other route that
56
aisle. See
Figure
9.
— For rails with square holes:
Attach the two L-shaped brackets to the rack rails, with two of the
#1/4-20 x 1/2 inch Phillips panhead screws, and two square washers
per bracket. Tighten the screws to a torque of 80 inch-pounds.
— For rails with round holes:
Attach the two L-shaped brackets to the rack rails, using two of the
#1/4-20 x 1/2 inch Phillips panhead screws (Item 8) per bracket.
Tighten the screws to a torque of 80 inch-pounds.
will be difficult to reach after the chassis is installed. Leave enough cable
allowance to plug and unplug cables from switch.
Core Switch 2/64 V4.1 Installation Guide
Advertisement
Table of Contents
