Table of Contents
Advertisement
Removing the Chassis Door
You must remove the chassis door before lifting the switch off the pallet. Use
these steps to remove the chassis door.
Note:
aisle into which exhaust air is released (usually called the "service aisle"). This
prevents the fans from pulling in heated exhaust air.
1. Open the door to a 90° angle.
2. Push the spring-loaded lever on the upper hinge up and into the notch in the
3. Push the spring-loaded lever on the lower hinge down and into the notch in
Figure 5: Sequence for detaching the chassis door from the hinges
Note:
Switch 2/64 off the pallet.
Core Switch 2/64 V4.1 Installation Guide
To ensure adequate cooling, install the chassis with the port side facing the
hinge. See
Figure
5.
the hinge, supporting the door to prevent it from falling. See
complete chassis door removal sequence.
1
Put the chassis door aside. You will need to reinstall it after moving the Core
Installing and Configuring the Core Switch 2/64
2
Figure 5
for the
3
SHR-2508A
45
Advertisement
Table of Contents
