Sample Output For The Configshow Command With "Fabric" As Filter - HP AA-RS2WC-TE Installation Manual

Figure 40: Sample output for the configshow Command with "fabric" as filter
11. Enter the haenable command.
12. If the switch configuration does not appear to have replicated correctly,
Note:
about downloading the correct configuration file. If this message displays, enter y to
continue.
Core Switch 2/64 V4.1 Installation Guide
SW0:admin> configshow "fabric"
fabric.domain:5
fabric.ops.BBCredit:16
fabric.ops.E_D_TOV:2000
fabric.ops.R_A_TOV:10000
fabric.ops.dataFieldSize:2112
fabric.ops.mode.fcpProbeDisable:0
fabric.ops.mode.isolate:0
fabric.ops.mode.longDistance:0
fabric.ops.mode.noClassF:0
fabric.ops.mode.tachyonCompat:0
fabric.ops.mode.unicastOnly:0
fabric.ops.mode.useCsCtl:0
fabric.ops.mode.vcEncode:0
<remaining output not shown>
SW0:admin>
download the switch configurations that were backed up (see
a. Enter the switchdisable command to disable the current logical
switch (should still be Switch 1).
b. Enter the configdownload command and enter the requested
information.
If the switch is running Fabric OS v4.0.2, a message displays cautioning you
c. Once the configuration has been downloaded, enter the switchenable
command.
d. Log into Switch 0 and repeat
Installing Core Switch 2/64 FRUs
step a through step c.
Figure 41).
147