Table of Contents
Advertisement
9. Log into the switch from the remote client as Admin. The default password is
Note:
modem cable connection to the active CP card.
10. Log out of the modem session.
11. Remove the telco connector from the active CP card modem, leaving the
Note:
detached while a session is active.
12. Dial-in to the telephone number assigned to the Core Switch 2/64, as
13. Observe the modem lamps: the Ring Indicator should flash only on the
14. Verify that after seven rings, the Off Hook indicator on the standby CP card
15. Reconnect the telco connector to the active CP card modem.
Note:
attached modems.
The Core Switch 2/64 requires approximately 5 minutes after a failover or reboot to
set up the modems.
Core Switch 2/64 V4.1 Installation Guide
password.
If the Off Hook lamp illuminates on the standby CP card modem, recheck the
standby CP card's telco line connected to the Y connector.
The modem session is automatically disconnected if the modem cable is
described in
step
6.
modem connected to the standby CP card.
modem is illuminated. A login prompt is presented to the remote client, and a
message confirms that the standby CP card is being logged into. You can now
log in or disconnect the session as desired.
The Core Switch 2/64 modems are now ready for use.
Advanced users can use the hafailover command to further evaluate the
Setting Up and Configuring Modems
223
Advertisement
Table of Contents
