Table of Contents
Advertisement
Installing and Configuring the Core Switch 2/64
Note:
rear of the rack. This mounting allows air to enter from the front of the rack and to
exhaust at the rear of the rack, similar to other rack-mounted equipment. This prevents
switch overheating, which may cause it to fail.
Note:
guidelines for installing a switch in the rack. Please note that the figures show
installation of an edge switch. Installing the Core Switch 2/64 in the HP System/e
Rack works similarly.
Use these steps to install the switch in the HP System/e rack.
1. Verify that all required hardware is available.
2. Choose a mounting location in the rack for the switch.
3. Install each of the two mounting brackets with (1) M5 Torx head screw with
Figure 12: Installing the mounting brackets
62
For proper airflow, the SFP media side of the SAN Switch 2/64 must face the
The HP System/e Rack installation procedure in this section provides general
captive lock washers as shown in
Figure
12.
Core Switch 2/64 V4.1 Installation Guide
Advertisement
Table of Contents
